cyclem(3G)cyclem(3G)NAMEcyclem - cycles between color maps at a specified rate
FORTRAN 77 SPECIFICATION
subroutine cyclem(durati, map, nxtmap)
integer*4 durati, map, nxtmap
PARAMETERS
durati expects the number of vertical traces before switching to the
map named by nxtmap.
map expects the number of the map to use before completing the
number of vertical sweeps specified by durati.
nxtmap expects the number of the map to use after completing the
number of vertical sweeps specified by durati.
DESCRIPTION
When the system is in multimap mode, cyclem allows you to switch from one
color map to another after a specified duration. In multimap mode there
are 16 color maps, numbered 0-15. You can use cyclem within a loop if you
want to cycle through more than one map.
EXAMPLE
The code fragment sets up multimap mode and cycle between two maps,
leaving map 1 on for ten vertical retraces and map 3 on for five
retraces.
call multim
call gconfi
call cyclem(10, 1, 3)
call cyclem(5, 3, 1)
SEE ALSO
blink, gconfi, multim
NOTES
This routine is available only in immediate mode and cannot be used in
onemap mode.
cyclem is not supported on Iris Entry, Indy, XL, XS, XS24, XZ, Elan and
Extreme systems and IRIS-4D RealityEngine systems.
Page 1