ISV(4) BSD Kernel Interfaces Manual ISV(4)NAMEisv — IDEC Supervision/16 image capture board
SYNOPSIS
isv0 at isa? port 0x2f0
isv0 at isa? port 0x2e0
isv0 at isa? port 0x3f0
isv0 at isa? port 0x3e0
DESCRIPTIONisv is a driver for the IDEC Supervision/16, an image capture board that
plugs into a 16-bit ISA bus. The IDEC Supervision/16 digitizes an NTSC
television signal, storing a 512 x 480-pixel, 8-bit grayscale image in
its 256kB dynamic RAM array every 1/30th of a second. The host reads
frames from the DRAM using 122881 16-bit I/O reads. Reading frames from
the Supervision/16 is quite slow: after the host reads a 16-bit word from
the DRAM, the Supervision/16 state machine takes approximately 0.5
microseconds to get ready for the next read. Theoretically, a frame rate
of approximately 10 frames per second is possible. isv achieves a frame
rate of approximately 6 frames per second.
SEE ALSO
Programming the Supervision/16 Image Capture Board, IDEC, circa 1991.
HISTORY
The isv device first appeared in NetBSD 5.0.
AUTHORS
The isv driver was written by David Young ⟨dyoung@NetBSD.org⟩.
BUGS
Synchronizing with the hardware and reading frames from it is very CPU-
intensive.
isv will not detect the capture board if it is not attached to an active
video source. To force NetBSD to detect the capture board at any time,
re-scan the ISA bus using, e.g., drvctl -r isa0.
BSD April 1, 2008 BSD