NDP(8) BSD System Manager's Manual NDP(8)NAMEndp — control/diagnose IPv6 neighbor discovery protocol
SYNOPSISndp-a [-lnt]
ndp-A wait [-nt]
ndp-c [-nt]
ndp-d [-nt] hostname
ndp-f [-nt] filename
ndp-H
ndp-I [delete | interface]
ndp-i interface [flags...]
ndp-p
ndp-P
ndp-r
ndp-R
ndp-s [-nt] nodename ether_addr [temp] [proxy]
DESCRIPTION
The ndp command manipulates the address mapping table used by Neighbor
Discovery Protocol (NDP).
-a Dump the currently existing NDP entries.
-A wait
Repeat -a (dump NDP entries) every wait seconds.
-c Erase all the NDP entries.
-d Delete specified NDP entry.
-f Parse the file specified by filename.
-H Harmonize consistency between the routing table and the default
router list; install the top entry of the list into the kernel
routing table.
-I [delete | interface]
Shows or specifies the default interface used as the default
route when there is no default router. If no argument is given
to the option, the current default interface will be shown. If
an interface is specified, the interface will be used as the
default. If a special keyword delete is specified, the current
default interface will be deleted from the kernel.
-i interface [flags...]
View ND information for the specified interface. If additional
arguments flags are given, ndp sets or clears the specified flags
for the interface. Possible flags are as follows. All of the
flags can begin with the special character ‘-’, which means the
flag should be cleared.
nud turn on or off NUD (Neighbor Unreachability Detection) on
the interface. NUD is usually turned on by default.
disabled
IPv6 can be disabled separately from other network proto‐
cols. This flag can be turned on automatically when
Duplicate Address Detection (DAD) indicates that another
device on the network is using the same link-local
address.
proxy_prefixes
the interface is enabled to proxy neighbor discovery for
global scope prefixes matching those on link at other
interfaces.
ignore_na
ignore neighbor advertisements received on this inter‐
face.
insecure do not use cryptographically generated addresses (CGA)
on this interface.
-l Show link-layer reachability information.
-n Do not try to resolve numeric address to hostname.
-p Show prefix list.
-P Flush all the entries in the prefix list.
-r Show default router list.
-R Flush all the entries in the default router list.
-s Register an NDP entry for a node. The entry will be permanent
unless the word temp is given in the command. If the word proxy
is given, this system will act as an proxy NDP server, responding
to requests for hostname even though the host address is not its
own.
-t Print timestamp on each entries, to make it possible to merge
output with tcpdump(1). Most useful when used with -A.
-x Show extended link-layer reachability information in addition to
that shown by the -l flag.
-w Show the cryptographically generated address (CGA) parameters for
the node.
RETURN VALUES
The ndp command will exit with 0 on success, and non-zero on errors.
SEE ALSOarp(8)HISTORY
The ndp command first appeared in WIDE Hydrangea IPv6 protocol stack kit.
BSD May 17, 1998 BSD
