TRACEENDS(1) User Commands TRACEENDS(1)NAMEtraceends - summarise traffic done by every endpoint observed in a
trace
SYNOPSIS
tracetopends [ -f bpf | --filter=bpf] [ -a addrtype | --address=addr‐
type] [ -H | --help]
inputuri [inputuri ...]
DESCRIPTIONtraceends reports the number of bytes and packets sent and received by
each endpoint observed in the input trace(s). Usually, you don't want
to run this program directly -- see tracetopends instead.
-f bpf filter
output only packets that match tcpdump style bpf filter
-A address type
Specifies how an endpoint should be defined. Suitable options
are "mac", "v4" and "v6" which will report endpoint stats for
each observed MAC address, IPv4 address and IPv6 address respec‐
tively.
OUTPUT
Output is written to stdout in columns separated by blank space.
The columns are (in order):
* Endpoint address
* Time last observed
* Packets originating from the endpoint
* Bytes originating from the endpoint (IP header onwards)
* Payload originating from the endpoint (post transport header)
* Packets sent to the endpoint
* Bytes sent to the endpoint (IP header onwards)
* Payload sent to the endpoint (post transport header)
EXAMPLES
Get stats for each individual MAC address in a trace:
traceends-a mac erf:trace.erf.gz
LINKS
More details about traceends (and libtrace) can be found at
http://www.wand.net.nz/trac/libtrace/wiki/UserDocumentation
SEE ALSOlibtrace(3), tracemerge(1), tracefilter(1), traceconvert(1), traces‐
plit_dir(1), tracereport(1), tracertstats(1), tracestats(1), tracepkt‐
dump(1), traceanon(1), tracesummary(1), tracereplay(1), tracediff(1),
tracetopends(1)AUTHORS
Shane Alcock <salcock@cs.waikato.ac.nz>
traceends (libtrace) September 2011 TRACEENDS(1)
