MOPPROBE(1) OpenBSD Reference Manual MOPPROBE(1)NAMEmopprobe - MOP Probe Utility
SYNOPSISmopprobe [-3 | -4] [-aov] interface
DESCRIPTIONmopprobe prints the Ethernet address and nodename of DECserver
100/200/250/300 on the Ethernet connected to interface or all known
interfaces if -a is given. If -o inhibits all messages but the first
from a node. With -v all MOP/RC SID messages will be shown (e.g.,
machines running DECnet).
The options are as follows:
-3 Ignore MOP V3 messages (Ethernet II).
-4 Ignore MOP V4 messages (Ethernet 802.3).
-a Listen on all the Ethernets attached to the system. If -a is
omitted, an interface must be specified.
-o Print a node just once.
-v Show all nodes sending MOP/RC SID messages.
SEE ALSOmopa.out(1), mopchk(1), moptrace(1), mopd(8)AUTHORS
Mats O Jansson (moj@stacken.kth.se).
OpenBSD 4.9 July 11, 2009 OpenBSD 4.9