vboxgetty.conf(5) Linux System Administration vboxgetty.conf(5)NAMEvboxgetty.conf - config file for vboxgetty
Description
The file /etc/isdn/vboxgetty.conf is used to configure vboxgetty.
Please read the man page vboxgetty(8) for a description of how
vboxgetty works.
Everything after "#" is ignored, as are empty lines. All arguments must
be separated by whitespace (spaces, tabs). Arguments may not contain
whitespace.
All settings before the first port command are global settings, after a
port command they only affect the current port.
port <string>
ISDN device to configure.
modeminit <string>
Command to initialize the modem. You should set the MSN/EAZ on
which vboxgetty should listen for incoming calls. Default is
"ATZ".
user <string>
Name of the user that vboxgetty will use. This user must exist
in /etc/passwd and you must use this parameter.
group <string>
Name of the group that vboxgetty will use. This group must exist
in /etc/group and you must use this parameter.
umask <number>
Vboxgetty will use this umask when creating new files. You must
give the umask as an octal number. Default is 077.
dropdtrtime <seconds>
Number of milliseconds to hold the DTR-Line low to reset the
modem. Default value is 800.
initpause <number>
Number of milliseconds to wait after initializing the modem.
This is used to compensate the delay of the "NO CARRIER"
response. Default value is 1500.
badinitsexit <number>
Maximum failures with modeminit. If this number is reached,
vboxgetty exits. Default is 0.
ringtimeout <number>
Time in seconds to wait for a RING. If no RING is received
within this time, no call is taken. Default is 5.
echotimeout <number>
Time in seconds to wait for the echo from the modem. Default is
4.
commandtimeout <number>
Time in seconds to wait for a response to a modem command.
Default is 4.
alivetimeout <number>
After this time in seconds vboxgetty will check if the modem is
still responding to modem commands. Default is 1800.
compression <string>
Audio compression to use to record new messages. Possible values
are ADPCM-2, ADPCM-3, ADPCM-4 and ULAW. The ALAW compression
mode is no longer supported. Default is ULAW.
spooldir <string>
Spool directory to use. This directory must exist. It's used for
control files of several programs. Default is
/var/spool/vbox/<user>.
vboxconfig <string>
Full path of the vbox config file. Default value is
<spooldir>/vbox.conf.
freespace <number>
Number of bytes that must be available on the partition with the
spool directory, so that a call may be taken. Default is 0.
debuglevel <string>
What messages are be written to
/var/log/vbox/vboxgetty-<device>.log. The string consists of
letters representing the severities of the messages to log
(F=FATAL, E=ERROR, W=WARNING, I=INFO, D=DEBUG, J=JUNK). Default
is FEWI.
FILES
/etc/isdn/vboxgetty.conf
this configuration file
SEE ALSOvboxgetty(8), vbox(5), vboxtcl(5)AUTHOR
This manual page was written by Andreas Jellinghaus <aj@dun‐
geon.inka.de>, for Debian GNU/Linux and isdn4linux.
ISDN 4 Linux 3.13 2003/03/11 vboxgetty.conf(5)
